Gift card holders
Purse gift card holder
measurements:
8 1/2" x 11 = cut two pieces at 7 3/4" x 5". score at 6" and 2 1/2"
DSP = cut two pieces
bottom front = 4 3/4" x 2 1/4"
top front = 4 3/4" 1 1/2"
basic instructions:
Cut on white 4 3/4" x 1 1/2" for sentiment for the inside top.
Use circle punch for finger slot in center of bottom inside panel.
Glue or tape bottom 3 sides.
Belly band = 1" x 8" score at 6 1/8" and 2 1/2" decorate belly band as desired.
DSP used: Stampin' Up
Pumpkin gift card holder
basic instructions:
Die cut large circle to form folded card. Cut off small section of folded circle card and glue to inside of card. This will hold the gift card inside card.
die cut 5 ovals to create pumpkin.
Glue oval to each side of center oval, then glue last two ovals to each side of the center ovals. Glue the pumpkin shape ovals to the front of the folded card. Free hand cut out a stem and glue to the top of the pumpkin.
These gift card holders were created for my local card swap gals.
Thank you for stopping by. Come back again soon.
3 comments:
Cute ideas.
Thank you. It's fun to go to pinterest or you tube and find different gift card holders.
These are so cute. I love making gift card holders. [Bunny]
Post a Comment