Fun Slider - pull up card

 Fun Slider - pull up card

stamp/supplies used:  Unity Doodle bird, Stampin' Up DSP, Prisma color pencils

This is a slider or some call it a pull up card ... whatever you call it ... it's FUN, and easy to create.

Slider Pull up card

stamp/supples used: Unity stamp co. Doodle bird, Stampin’ Up (pattern papers) DSP

measurements:

base card: 5 ½” x 8 ½” scored at 4" & 8"

white (inside slider card) cs: 3 ¾” x 5”

outside slider can be any size or shape

mechanism strips – ¾” x 3”

Front DSP (pattern paper) - 3 ¾” x 5 ¼”

Basic instructions:

With ½” fold on left hand side in trimmer, line it up at 1 ½” in trimmer. Cut from 1” to 4 ½”. This creates slit for the slider. Add tear & tape to ½” section.

Add foam tape on one end of mechanism strip. Flip strip over and add tear & tape on end of mechanism strip. Slide strip through slit with tear & tape inside card, foam tape showing through front of card. Punch half circle thumb hole on top of front of card.

Slide strip to bottom of card. Adhere 3 ¾” x 5” (inside white panel) to slider strip with tear & tape on it that will be on the inside of the card. Peel off backing of tear & tape and close card.

Add stamped layer to front of card on the mechanism strip with foam tape. See photo above.

Thanks for stopping by.  Come back soon.